20W 250..600mA 9-45V TRIAC Dimmable LED Driver

AURA+ ALCC020 LED DRIVER SERIES

SMALL-SIZED CONSTANT CURRENT LED DRIVER WITH TRIAC DIMMING - ALCC020-00600-045-TRIAC

FEATURES

• Single channel output, output current level selectable by DIP Switch

• Support Leading edge (Triac) and Trailing edge (ELV) dimmer

• Input Voltage 220-240VAC

• Built-in active PFC function

• Class 2 power supply. Full protective plastic housing

• Dimming effect smooth, no flicker

• Protections: Short circuit, over load, over voltage

• Small Size

• Half Potted Electronics

• Flicker Free

• IP20

• With Wires

APPLICATIONS

Downlights, Panel Lights, Spotlights, Ceiling Lights, Decorative Lights, Floor Lights, Track Lights and Flood Lights

IP Class

IP20

Constant Current

250mA

300mA

350mA

400mA

450mA

500mA

550mA

600mA

TECHNICAL DATA

OUTPUT

DIP Switch Technical Values

• 250mA 9-45V 11.25W
• 200mA 9-45V 13.5W
• 350mA 9-45V 15.75W
• 400mA 9-44V 18W
• 450mA 9-44V 19.8W
• 500mA 9-40V 20W
• 550mA 9-36V 19.8W
• 600mA 9-33V 19.8W

Channel: 1
No load output voltage: 60V Max
Frequency: 2 KHz PWM
Current Accuracy: ±5%
LF current ripple(<120Hz): <3%

INPUT

Voltage: 220-240VAC
Frequency: 50/60Hz
Efficiency: 79%@230VAC, Full load
PF: 0.92@230VAC, Full load
THD(full load): <20%@100VAC, Full load
Current: 0.2A max @230VAC
Inrush Current: Cold start, 10A@120VAC

PROTECTIONS

Over Voltage: Hiccup, recovers after fault condition is removed
Over load: Hiccup, recovers after fault condition is removed
Short circuit: Close output, recovers automatically after fault removed

DIMMING

Dimming type: TRIAC
Dimming range: 3%-100%

OTHERS

IP rating: IP20
Working temp.: -20 ~+50°C
Tc.: +90°C
Relative humidity: 20~90% RH
Lifetime: 50,000h@tc:+70°C
Switch cycle: >25,000 times
Warranty: 5 years

DIMENSIONS

Lenght: 88mm
Width: 43mm
Height: 26.5mm
Lenght of the wires: 150mm
Stripping Length: 10mm
Weight: 105g
Packing Size: 50pcs is carton
Material: PC

SAFETY

Surge: L-N:0.5kV;
Withstand Voltage: I/P-O/P: 3000VAC/1min/5mA
Safety standards: EN61347-2-13
EMI Eission: EN55015
EMC Immunity: EN61000-3-3 EN61000-4-3 EN61000-4-4 EN61000-4-5

CAUTIONS

1. This product should be installed by qualified personnel.
2. This product is non waterproof, need to avoid sun and rain.In case of outdoor use, please ensure it is mounted in a water proof enclosure. Good heat dissipation conditions extend product life.Please install the product in a well-ventilated environment.
3. Please make sure LED power supply output voltage, current is used to meet the product requirements.
4. Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current. Please also ensure that the cable is secured tightly in the connector.
5. Due to safety concerns, PVC or rubber cord of 0.75-2.5mm2 is recommended for input and output terminal(s) (excluding signal terminals). Flat power cord is not suitable.Ensure all wire connections and polarities are correct before applying power to avoid any damages to the LED lights.
6. In case of malfunction, do not repair it yourself.